Top rated power press machine supplier with Pressmachine-World? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. Find extra information on power press machine. Through this partnership of shared experience and ideas, we are confident that we can realize your current and future requirements on WORLD press machine.
Even if there are shelves full of molds, don’t assume that these molds are suitable for the newly purchased machine. The wear of each mold must be checked by measuring the length from the front end of the punch to the shoulder and the length between the shoulder of the female mold. For conventional ols, the deviation per foot should be about t0.001 inches, and the total length deviation should not be greater than t0.005 inches. As for the precision grinding mld, the accuracy per foot should be ±0.0004 inches, and the total accuracy should not be greater than ±0.002 inches. It is best to use fine grinding molds for CNC bending machines, and conventional molds for manual bending machines.
Main features: Adopt all-steel welded structure, with sufficient strength and rigidity; Hydraulic drive, the oil cylinders at both ends of the machine tool are placed on the sliding block to directly drive the sliding work; The slider synchronization mechanism adopts torsion shaft for forced synchronization; Using mechanical block structure, stable and reliable; The stroke of the slider can be adjusted quickly by motor, fine-tuned manually, and the counter is displayed; Oblique wedge-type deflection compensation mechanism to ensure higher bending accuracy.
As far as free bending is concerned, punch and die are procese at 85 or les (saler i better). When using this set of molds, pay attention to the ga beteen the male mold and the female mold at the bottom of the stroke, and the excessive bending that is sufficient to compensate for the springback and keep the material at about 90°. Generally, the springback angle of the free bending die on the new bending machine is s2, and the bending radis is equa to 0.156 times the opening distance of the die. For the bending of bottomed concave molds, the mold angle is generally 86 ~ 90°. At the bottom of the stroke, there should be a gap slightly larger than the thickness of the material between the male and female molds. The forming angle is improved because the bottomed die has a larger bending tonnage (about 4 times that of free bending), which reduces the stress that usually causes springback in the bending radius.
Aluminum and high-strength steels, for example, place special demands on the individual processing steps. One factor that has a major influence on the quality of the end product is the straightening of the respective metal. In a straightening machne consisting of several stagered straighngos,the coilcrvatre o the starting matril is elmnated. In adition, any edge or centre waves in the strip material can be compensated for, using suitable machines. The aim here is to achieve the lowest possible and most homogeneus resiu sres state in order to maintain te flatness of the material during subsequent cutting processes. n lentr mesur fo th eciecy of a straighten roessis te dere of platification of the respective metal, which describes the proportio o he material os-section that is plastically deforme uring straightening. With the same yield strength and material hickness, aluminum requires significantly greater degrees of deformation than steel to achieve comparable plastification. Find more information at https://www.pressmachine-world.com/.